Home › Services › Kitchen Peninsula Removal
Kitchen Peninsula Removal in the Houston Metro
Most people who call about kitchen peninsula removal have a complaint that is more specific than the request. The kitchen feels closed off. Two people cannot pass. You cannot see the television, or the kids, or the back door from…
- Licensed & Insured
- 20+ years remodeling
- 17 cities served
- 102 ZIP codes covered
In short
The ladder runs roughly like this. The lightest move is removing whatever hangs above it, since a bulkhead or a run of upper cabinets over a peninsula blocks more sightline than the base ever did. Next is dropping a raised bar top to a single counter height, which opens the view and gains usable…
What the work involves
The ladder runs roughly like this. The lightest move is removing whatever hangs above it, since a bulkhead or a run of upper cabinets over a peninsula blocks more sightline than the base ever did. Next is dropping a raised bar top to a single counter height, which opens the view and gains usable surface without touching plumbing or the slab. Next is shortening the run by a cabinet or two to widen the aisle, which means a new finished end panel, a countertop cut or remake, and a flooring patch at the footprint. Full removal comes after that: cabinets and top out, any sink or cooktop disconnected, supply and drain capped, electrical circuits properly terminated in accessible boxes, drywall and backsplash repaired where it abutted, and flooring made continuous. The largest version replaces it with an island, which on a slab means new penetrations rather than fewer.
What gets specified, and why
What gets specified depends on which rung you choose. Capping work uses DWV fittings appropriate to the existing material, no-hub couplings where cast iron is involved, and proper caps rather than a taped-over stub. Supply lines get cut back and capped at an accessible point, never buried behind finish. Slab patching uses a clean cut, a compacted base, a vapour retarder, and concrete matched for thickness, with the understanding that a patch and the original slab will move independently. That is why crack-isolation or uncoupling membrane goes over the joint before tile: without it, seasonal movement in expansive clay telegraphs a crack straight up the grout line. Flooring patches rarely match, since tile under cabinets was usually never laid; plan on a deliberate transition, a feature strip, or refloor. Countertops need a remade end, which on quartz or granite means a shop cut and often a seam.
Why the Gulf Coast changes this job
On Houston slab-on-grade construction, the decision hinges on what comes up through the floor. A peninsula sink means a drain stub and supply lines cast into or run beneath the slab. Abandoning them properly usually means saw-cutting the slab, capping the drain below floor level, and pouring back. In post-1985 stock across Katy, Cypress and Fulshear, that slab is very often post-tensioned, and cutting one of those without locating tendons first is not a risk worth taking; a scan comes before the saw, every time. In 1960s to 1980s inner-loop houses the drain under the slab may be cast iron, which changes how it is cut and capped. None of that applies if the peninsula holds nothing wet. That single fact, sink or no sink, moves this job between two very different categories of work.
Where these jobs go wrong
The most expensive mistake is removing everything when removing the bulkhead would have done it. The second is discovering, after demolition, that the bulkhead above the peninsula carried a kitchen vent stack or an HVAC trunk, and that the ceiling cannot simply close flat. The third is electrical: circuits feeding peninsula receptacles get cut and buried in the wall or under a patch. Splices must remain accessible, and a dead circuit should be identified and terminated at the panel, not abandoned live behind drywall. Fourth is plumbing: capping a drain at floor level and tiling over it leaves a future owner with a mystery and a leak path. Fifth is flooring: nobody checks whether the existing floor runs under the cabinets, and it usually does not, so a footprint-shaped hole appears at the end of a job that was quoted without it. Sixth is cutting a post-tensioned slab without a scan.
What moves the price
Whether the peninsula is wet is the largest single factor. Cabinets and a countertop coming out is bounded work; slab cutting, drain capping, pour-back and cure is a different scale. Post-tension scanning adds cost and schedule. Flooring is the sleeper: matching a discontinued tile is often impossible, so the real comparison is a visible patch versus refloouring the room. Countertop work depends on the material, since a remade end in quartz or granite is shop work with a possible seam. Bulkhead removal adds cost sharply if a vent, duct or wiring lives inside it. Electrical termination is modest unless the panel needs attention. Permits apply to plumbing and electrical changes in most jurisdictions here, and the local authority sets that scope.
How a project runs
We start by asking what the complaint actually is, then measure the aisle and look above the peninsula before looking below it. If there is a sink or cooktop in it, we establish where the lines run and whether the slab is post-tensioned. We give you the ladder with real scope attached to each rung, so you can pick the smallest change that fixes the problem rather than the largest change available. Once chosen, wet work and any slab work come first, then framing and drywall, then flooring, then countertop and finish. Call MS Home Remodeling at (281) 235-6971 to walk the kitchen.
Common questions
Can I remove just the upper cabinets over the peninsula?
Often yes, and it is the highest-impact-per-dollar move available. What matters is what is inside the bulkhead above them. On 1970s kitchens those soffits frequently carry the kitchen vent stack, wiring, or an HVAC branch, which means the ceiling cannot simply be closed flat. We open a small inspection hole before quoting that work rather than after.
Why is removing a peninsula sink such a big deal?
Because on a slab house the drain and supply come up through concrete. Abandoning them correctly usually means saw-cutting the slab, capping below floor level, and pouring back, then dealing with a patch that moves differently from the original slab. Add a post-tension scan on newer western-suburb homes. That sequence is the difference between a cabinet job and a concrete job.
Will the floor match after removal?
Usually not. Tile and wood are rarely installed under cabinet runs, so removal leaves a bare footprint the exact shape of the peninsula. If the original material is still available and the installation is old enough to have shade variation, a patch can read as a repair. Most people end up choosing between a deliberate transition detail and reflooring the kitchen.
Kitchen Peninsula Removal by location
We cover 102 ZIP codes across the Houston metro. Pick the area closest to you:
- Bellaire 77401
- Brookshire 77423
- Cypress 77429
- Cypress 77433
- Fresno 77545
- Fulshear 77441
- Houston 77002
- Houston 77003
- Houston 77004
- Houston 77005
- Houston 77006
- Houston 77007
- Houston 77008
- Houston 77009
- Houston 77010
- Houston 77011
- Houston 77014
- Houston 77016
- Houston 77018
- Houston 77019
- Houston 77020
- Houston 77021
- Houston 77022
- Houston 77023
- Houston 77024
- Houston 77025
- Houston 77026
- Houston 77027
- Houston 77028
- Houston 77030
- Houston 77031
- Houston 77033
- Houston 77035
- Houston 77036
- Houston 77037
- Houston 77038
- Houston 77039
- Houston 77040
- Houston 77041
- Houston 77042
- Houston 77043
- Houston 77045
- Houston 77046
- Houston 77047
- Houston 77048
- Houston 77051
- Houston 77053
- Houston 77054
- Houston 77055
- Houston 77056
- Houston 77057
- Houston 77060
- Houston 77063
- Houston 77064
- Houston 77065
- Houston 77066
- Houston 77067
- Houston 77068
- Houston 77069
- Houston 77070
- Houston 77071
- Houston 77072
- Houston 77074
- Houston 77076
- Houston 77077
- Houston 77079
- Houston 77080
- Houston 77081
- Houston 77082
- Houston 77083
- Houston 77084
- Houston 77085
- Houston 77086
- Houston 77087
- Houston 77088
- Houston 77090
- Houston 77091
- Houston 77092
- Houston 77093
- Houston 77094
- Houston 77095
- Houston 77096
- Houston 77098
- Houston 77099
- Houston 77204
- Katy 77449
- Katy 77450
- Katy 77493
- Katy 77494
- Missouri City 77459
- Missouri City 77489
- Orchard 77464
- Richmond 77406
- Richmond 77469
- Rosenberg 77471
- Simonton 77476
- Spring 77379
- Stafford 77477
- Sugar Land 77478
- Sugar Land 77479
- Thompsons 77481
- Tomball 77377
Planning kitchen peninsula removal?
We measure, look at the slab and the existing rough-in, and give you a scope you can actually compare against another bid.
MS Home Remodeling · 1530 W Sam Houston Pkwy N, Houston, TX 77043 · (281) 235-6971