We handle bathroom remodel contractor across 77433 in Cypress, roughly 14 miles from our Energy Corridor base.
A bathroom remodel in a 1972 house off Memorial and the same-sized bathroom in a 2006 house in Cypress are not the same job, even if the finished pictures look alike. The differences are all behind the drywall: what the drain is made of, how the slab was built, how the wiring was run, whether the framing is dimensionally what it says it is, and what has been quietly leaking. Pricing the two the same way is how homeowners end up with change orders they did not expect. This page sets the two side by side and explains what each era hands you on demo day.
Why this is different on the Gulf Coast
Both eras sit on Houston’s expansive clay, and both move. What differs is how they show it. Older slabs, conventionally reinforced, tend to crack and settle in ways you can read: a hairline that runs under the floor tile, a door that binds in August and swings free in February, a tile grout line that keeps opening no matter how many times it is filled. In a bathroom that argues for an uncoupling or crack-isolation membrane under new floor tile rather than bonding tile straight to the concrete.
Newer post-tension slabs move too, but they move as a plate, and their real constraint is that you cannot cut one casually. Scanning before coring is not optional.
Humidity hits the two differently as well. The older house often has no insulation in the bathroom’s exterior wall and an original fan that barely moves air, which is why the ceiling paint blisters. The newer house is tighter, so a weak fan traps moisture just as effectively. The fix is the same in both: real capacity, insulated duct, terminated outside.
What we actually do
In an older inner-loop house, the first hour after demo is an inspection. Drain lines are often cast iron, joined with lead and oakum, and may be scaled internally or thin along the bottom of the run. Supply may be galvanized steel, which chokes down with rust and drops your pressure, or early copper. Framing is real dimensional lumber, which is stronger but rarely plumb after fifty years of slab movement, so tile walls need shimming and furring before backer board goes on. Ceilings may be popcorn, which in a pre-1980 house should be tested before anyone scrapes it. Wall cavities are frequently uninsulated. Branch wiring from the late 1960s and early 1970s occasionally turns out to be aluminium, which an electrician needs to evaluate and terminate with listed connectors.
A 2000s Katy or Cypress house is more predictable. PVC drains, PEX or copper supply, engineered framing, insulated exterior walls, and a post-tension slab. The problems shift: the slab cannot be cut without scanning for tendons, so drain relocation is a bigger decision than it is in an older house. Builder-grade cabinet boxes are usually particleboard and have often swollen at the toe kick. Garden tubs with a tile deck are extremely common and are the single most requested thing to remove, since that deck footprint is where a good shower fits.
What moves the price
In the older stock, the cost drivers are discoveries. Failed cast iron, galvanized supply, rot at the bottom plate behind a tub, an out-of-plumb wall that needs furring, an undersized panel that cannot take another circuit, or popcorn ceiling that tests positive and requires abatement by a qualified firm. None of these are visible when you quote the job from the doorway, which is why an honest older-home estimate carries allowances.
In the newer stock, the cost drivers are choices. Removing a garden tub and rebuilding that footprint as a shower is straightforward until you want a curbless entry, which on a post-tension slab means either recessing within the limits scanning allows or building the floor up and dealing with the door threshold. Frameless glass, large-format porcelain, and a linear drain all add.
Both eras share one driver: whether the drain moves. That single decision separates a finish-level job from a concrete-cutting job.
Cypress homes and this work
Cypress is mostly unincorporated northwest Harris County, and the housing reflects a building push that ran from the 1990s straight through the 2010s. Post-tension slab, brick across the front, two stories, a tall entry, a garden tub the family stopped using years ago, and cabinet boxes that are particleboard behind a solid door. That last detail matters in this climate: particleboard swells if a supply line weeps or a dishwasher leaks, and it does not come back. When we rebuild a kitchen here we move to plywood boxes. The rest of the pattern is predictable and fixable — builder carpet, a wall between the kitchen and family room that no longer makes sense, a formal dining room nobody eats in. These are newer homes, but they sit on the same expansive clay as everything else, so substrate flatness and movement joints still decide whether your tile looks right in year five. Most neighborhoods have deed restrictions and architectural review for exterior changes.
What to expect
We start by asking the age of the house and looking at what it tells us — panel type, visible supply material at the water heater, whether the slab is post-tension, and how the existing bathroom has been behaving. On older homes we recommend a camera look at the drain before finalizing scope, because it is far cheaper to know now.
Selections follow, then permits where required, then demo. On older houses we build a deliberate pause after demo: walls open, everything visible, and a walkthrough with you to decide on anything that turned up. On newer houses that pause is shorter, because there are fewer surprises.
From there it is rough-in, inspection, waterproofing and flood test, tile, finish, and a punch walk.
Common questions
How do I know if I have a post-tension slab?
Newer suburban construction in Katy, Cypress, Fulshear, and much of Fort Bend commonly uses post-tension. Many homes have a stamped warning plate at the garage slab edge or a note in the original documents. Before we cut concrete for any drain relocation, the area is scanned regardless — a cut tendon is a serious and expensive repair, and scanning costs a fraction of finding out the hard way.
Is galvanized supply piping something I have to replace?
Not automatically, but it is worth judging honestly while the wall is open. Galvanized steel corrodes from the inside and narrows over decades, which shows up as weak flow, discoloured first-draw water, and pinhole leaks. If your bathroom's branch is galvanized and the wall is already open, repiping that section is far cheaper now than after the tile is set. Whole-house repiping is a separate conversation.
Why does my tile floor keep cracking along the same line?
That is usually the slab telling you something, not bad tile. Our clay soils swell and shrink seasonally, and a crack in the concrete will telegraph straight through tile bonded directly to it. The remedy on the new floor is an uncoupling or crack-isolation membrane between slab and tile, plus movement joints at the perimeter and where the field meets restraining surfaces, rather than grouting tight to every wall.
My 1970s house has popcorn ceilings. Can you just scrape them?
Not without testing first. Texture applied before the early 1980s can contain asbestos, and the only way to know is a lab test of a sample. If it comes back positive, removal is work for a licensed abatement contractor, not a remodeler. If it comes back clean, scraping and refinishing is routine. We will not disturb an untested pre-1980 ceiling, and you should be wary of anyone who offers to.
Do you cover Cypress 77433?
Yes. Cypress 77433 is about 14 miles from our shop at 1530 W Sam Houston Pkwy N, Houston, TX 77043, inside the area we work in daily. Call (281) 235-6971 to arrange a site visit.
MS Home Remodeling — bathroom remodel contractor in Cypress, TX 77433. Call (281) 235-6971 for a site visit.